Lightweight portable hole cutting machine with vacuum base

This unit consists of a vacuum base to clamp to the surface of the material and an air feed cylinder to push the cutter through without any effort by the operator.

It also incorporates a safety valve which will not allow air to be supplied to the drill motor unless it is locked to the surface.

Vac-Force 2000
Due to the design, the surface to which the unit will adhere to the surface (does not have to be smooth and flat). Certain surface imperfections causing vacuum losses are tolerated (eg. aluminium tread-plate), due to constant vacuum generation.

LIGHTWEIGHT
Weighing only approximately 4.5kg the VAC-FORCE 2000 has instant advantages over magnetic based drills which weigh 13.0kg plus and are restricted to ferrous materials. Its lightweight construction enhances its portability, saving time in relocating when cutting multiple holes.
Safety cables are not required when operating at heights. The hovercraft effect when the release button is pressed makes centre pop location easy.

FACTS:
Length: 280 mm
Width: 89 mm
Height: 280 mm
Air pressure: 6 bar
Pipe: Ø 50 – 600 mm
Material: All

Vac Force Kit for your specific use:
Using Kit #1 Battery Drill with Standard Drill Chuck to suit 1mm-13mm twist drills & holesaws.
Using Kit #2 Battery Drill to suit Mini Cutters. Available from 8mm to 25.5mm Dia. 16mm DOC.
(Recommended for drilling Mild Steel, Stainless Steel, Aluminum and Brass)
Using Kit #3 Battery Drill Arbour with 19mm Shank Broach Cutter
(Recommend with high torque battery drill, Broaching up to 40mm Dia)
* Note drill bits are not included, Kits do not include battery or Air drills.

Compatible with Most Brand Battery Operated Portable Drill Units, and Pneumatic Drilling systems.